Expand Quote
Nah and no response when I’ve asked and they’ve never uploaded it. I’m tempted to rip it for my own records though and if I do I can share it with you hotdogs.
please do! also curious if there is a good trick for getting trucks mounted centered and square?
If you’re looking for an alternative method, this worked for me:
Run a thin piece of masking tape down the center of the board and then draw a fine line down the center of the tape.
Also write “front” and “back” on the bottom of the baseplates to avoid future confusion.
Mark 3.5 in. from each end (or whatever you want your nose/tail length to be).
Set the pivot side of the baseplate on the mark, then carefully line up the baseplate straight and centered using the holes and centerline to guide you.
Hold the baseplate down against the tape with a finger and use an awl to poke small divots into the board through the baseplate holes.
Remove tape, drill pilot holes through the divots you made, apply stickers if desired, and mount trucks.