Converted to Ace's last month, but have been kinda busy with school so I haven't skated them much until recently. Set them up with the krux bushings, no bottom washer, with the nut just below flush with the kingpin. Pretty wobbly but really stable.
Honestly it didn't feel like the turn was that much more remarkable than Indy's, not sure if I could even really tell the difference. I don't have a good park to skate but I'm guessing the difference might be more notable pumping around transition. What I did notice is that there is significantly less wheel bite than my indy's had, and thats what really sold me on them so far. I feel like all brand new wobbly trucks are going feel a lot more stable when compared to old and beat up ones.
Over the more recent sessions the bushing have packed in a little more, for some extra wobble. I was kinda trying to wait as long as I could before I tightened the kingpin nut any more, but slowly both kingpins have came loose and are moving around. I tightened down the nut and the kingpins don't have too much room to move, but its enough to bug me, and I'm worried that they are just going to get worse. Pretty bummed that this is happening after only 6-7 sessions. Not sure if I can fix them my self, should replace the kingpins completely, or if I should just try to contact Ace about it. Pretty happy with the trucks otherwise, but I don't want to deal with loose kingpins on trucks that are so new.