Because I love you all...
Good luck A) getting it out and B) getting it into another plate, not gonna happen. It's in there tight, doesn't fall out/zero wiggle. Got to admit it's nice to have a baseplate that works with no risk of the nut falling out (no clue how film does it)
Stock pin + washer
Krux pin + washer
7g lighter using Krux Pin (meh)
Tiniest bit more grind clearance with the Krux pin (L)
You can see the underside hanger curve has changed compared to the TI Hanger; I never noticed how much shorter the front part of the forge plates are compared to cast - Mid hanger has more lean towards the center of your board than the upright-ness of the forged
(L) Indy Mid Cast Plate/Standard 144 | (R) Indy Forged plate TI 144
Plates flush against and edge, WB is clearly tighter than the forged/and you can see one image above that the lean of hanger is more forward than upright)
(L) Indy Mid Cast Plate/Standard 144 | (R) Indy Forged plate TI 144
(L) Indy Mid Cast Plate/Standard 144 | (R) Indy Forged plate TI 144
Mid Hanger Forged plate
(L) Indy Mid Cast Plate/Standard 144 | (R) Indy Mid cast plate
TI hanger 144
(L) Indy Forged TI 144 | (R) Indy Mid hanger 144
FORGED PLATE 144
(L) Indy Mid Cast Plate/Standard 144 | (R) Indy
FORGED plate
Mid Hanger Standard (50.5mm now?)
Setting them up now, will measure WB compared to the forged TI will post feedback after.